Table of Contents
Advertisement
2.) If it is a DCE InfoWave unit, which connects to a computer, slide the switch
to DTE side, and if it is a DTE InfoWave unit, which connects to a modem,
slide the switch to DCE side. Please note that you need to unplug the RS-232
cable during the synchronization procedures.
3.) Turn on the power of each InfoWave unit by pressing the power switch again.
4.) After each unit's PWR LED has slowly blinked 3 times and then begun to
flash faster, slide the switch back to the original position.
5.) The PWR LED will now slowly blink 3 times and then light up solid.
After these steps are completed, the two InfoWave units should be able to operate
flawlessly. If you still encounter any difficulties, please contact InnoMedia's technical
support.
The InnoMedia Wireless Group
http://www.innomedia.com/wireless/
11
Advertisement
Table of Contents
