Table of Contents
Advertisement
InfoWave Hardware
The following figure and table describe the InfoWave hardware.
Reference
1
Power Indicator
2
DCD Indicator
3
DTE Indicator
4
5
Power Switch
6
DTE-DCE Switch
7
DC Power Input
8
9-pin Serial Port
9
25-pin Parallel Port
The InnoMedia Wireless Group
Function
Indicates power is on when lit.
Flashes when in Sync mode.
Indicates unit is connected when lit. Light
blinks when transferring data and turns off
after 30 seconds of inactivity.
Set unit to DCE mode for connecting to a
computer and the indicator is off. When it
turns on, the unit is set to Sync mode. In Sync
mode, two InfoWave units synchronize their
PN codes.
Antenna
Transmits/Receives signal to/from another
unit.
Press into the lock position to turn on the unit.
Press again to turn off the unit.
Slide to the left for synchronization, and to the
right for normal data communication.
+5V DC power input. Positive polarity is at
the center.
Female 9-pin connector for serial connection
to a PC or serial communication device.
Reserved for OEM use
(Optional)
http://www.innomedia.com/wireless/
Description
7
Advertisement
Table of Contents
