Table 1-7 Time Settings Fields - Honeywell HCX13MW Operator's Manual

32
Table 1-7 Time Settings Fields
Field Description
time zone Select the time zone where your camera is located
clock date Adjust the date of your camera, in MM/DD/YY format.
(HCX3W/HCX5
DW)
clock time Adjust the time of your camera in 24 hour format (HH:MM:SS).
(HDX3W/HCX5 Before adjusting the clock time, make sure that you have already
DW) selected the appropriate time zone for your camera.
timeserver The timeserver protocol used by your network. Options are:
protocol
none means your camera does not obtain its time from the
network
ntp (default)
daytime
timeserver IP The IP address of the timeserver on your network (if any).
address
Note
Note
NTP mode These items apply only when the timeserver protocol is set to
NTP. Options are:
passive enables or disables acceptance of incoming time
broadcasts sent by an NTP server on the local subnet.
broadcast (default) enables or disables your camera sending
NTP broadcasts to find a time server on your local subnet. If you
have set a timeserver IP address, then that is the timeserver used.
In this case, a broadcast is sent only if the specified timeserver
fails to respond.
both sends out NTP broadcast requests and listens for incoming
NTP packets.
Do not enter a DNS name. You may set this to 0.0.0.0. to
specify none.
When the NTP mode (below) is set to passive, entries in
this field have no effect.