Setting Relay Action; Configuring Analog Output; Figure 1-26 Relay Action Dialog; Figure 1-27 Analog Output Dialog - Honeywell HCX13MW Operator's Manual

Setting Relay Action

Configuring Analog Output

Document 800-01794 Rev C
05/09
Figure 1-26 Relay Action Dialog
Table 1-14 Relay Action Fields
Field Description
relay state The normal, non-activated state of the relay
activation time The duration of the activation. Options are:
momentary activates the relay for a fraction of a second.
toggle causes relay activation to change the relay's state from
open to closed or from closed to open.
forced The minimum time between trigger events, including those from
idletime the external relay, motion, and from relay button presses. Your
camera will not trigger another event until the specified amount of
time elapses after the last post-trigger image. Set up trigger events
on the Trigger Settings screen (see "Trigger Settings" on page 36).
This is the same setting as the forced idle time item on that screen.
activate on When enabled, motion trigger events—configured on the Motion
motion Settings screen—activate the relay output.
activate on If enabled, the external relay input activates the relay output.
external
trigger
Select what is output on the analog video connector.
Figure 1-27 Analog Output Dialog
HCX Series Network IP Camera Operator Guide
43