Software (Firmware) Update - Panasonic Diga DMR-BW780 Operating Instructions Manual

Software (Firmware) Update

Software of this unit can be updated automatically by
following method in standby mode at the specified time
(Default setting is 3 a.m.
≥From broadcasts
≥From Internet [network connection and setting is required.
( 13, 19)]
≥The time it takes to update depends on the connection.
– For Broadcast: About 2 to 4 hours
– For Internet: About 1 hour
The download time differs depending on the network
environment.
∫ If a software (firmware) update is
available, a notification is displayed.
New software version has been found.
The software will be updated automatically
after this unit is switched to standby.
Do not disconnect the AC mains lead.
≥It is displayed on the Digital channel information (
when the Software (Firmware) can be updated
immediately.
1
Dogs and Cats
9:00 - 11:00
Rating: PG Dolby D
To execute, push the "Red" button while the digital
channel information is displayed, and follow the
instructions on the screen.
≥Update of the software (firmware) will start when the power
is turned off.
84
VQT2J69
83, Software Update in Standby)
All Digital Channels
10:30
Select favourites
Software upgrade
Now
∫ The unit's display during the update
e.g.,
≥When "FINISH" is displayed, update of the software
(firmware) has completed.
You cannot operate the unit until the update is
complete. Removing the AC mains lead while the
update is in progress may damage the unit. Don't
remove the AC mains lead during the update.
≥ If the timer recording is scheduled within the following time at the start of
the download, the download will not be executed.
– For broadcast: Within 4 hours
– For Internet: Within 1 hour
≥ You can also download the latest software (firmware) from the following
website and burn it to a CD-R to update the software (firmware).
http://panasonic.jp/support/global/cs/
≥ If you do not want to perform the software (firmware) update, set the
"Software Update in Standby" in the Setup menu to "Off". (
21)
83)