Automatic Defrosting; Ice Making - Mitsubishi Electric MR-385R Operating Instructions Manual

2. Automatic defrosting

Thanks to the built-in automatic defrosting timer and the defrosting heater, defrosting is performed automatically in this
refrigerator.
There is, therefore, no need to defrost it. Water produced during defrosting passes through the drainage hose at the rear
and collects in the drain pan at the lower part of the refrigerator's back.
Then, it automatically evaporates with the heat from the radiator.

3. Ice making

Pour water into each of the sections of the ice tray up to the water line. Insert the tray completely into the ice tray
holder. (The ice cubes will not separate easily from the ice tray if you add too much water.)
Once the ice cubes are made, turn the lever until the ice cubes fall into the ice cube storage box.
The ice cube storage box will break if you attempt to make ice directly in the ice cube storage box.
4. Slide chilled compartment
This slide chilled compartment is cooled down to about 0
Opens by pulling out the case.
CAUTION:
Before closing the refrigerator compartment door, make sure that the chilled case is pushed in all the way
(the lid is closed correctly).
Remove the lid and chilled case as in the figure and proceed with cleaning.
Comes off by pulling out the case, open the lid, then pull out while holding the right-hand side with the lid moved
towards the left-hand side. (Fig. 1)
Comes off by pulling the case out all the way, then pulling out while holding and lifting the edge of the case upwards.
(Fig. 2)
Fig. 1
o
C to preserve freshness of foods stored for a long time.
Lid
Chilled case
Fig. 2
4