Cleaning The Automatic Ice Maker - Mitsubishi Electric MR-B46F Operating Instructions Manual

Cleaning the Automatic Ice Maker

Perform cleaning periodically to prevent
mold, water scale, and other contamination.
Water Tank and Water Supply Pump
Once a week
Mold, water scale, and other contamination form easily
in certain types of water. If this occurs, clean 2 or 3 times
a week.
* Drain the water out when you will not be making ice.
1
Remove the water tank,
and remove the lid and
tank cap.
Turn the tank
cap to remove it.
When using bleach to clean the water
tank and lid, follow the product
instructions.
2
Pull out the tank packing
from the water tank.
Invert the water tank.
3 Pull out the tank pipe and
rotate the water supply
pump in the direction of
the arrow to remove it.
Water Supply Pump
4
Disassemble the
water supply pump.
Open the tab and
remove the cap lid.
Impeller
The impeller is made
from a magnet. Wash it
thoroughly to remove any
foreign substances.
5
Wash each part with water.
 Do not use a sponge, scrubber, or similar item when
cleaning. Scratches on the surface may cause malfunction.
Requests
 Do not use a dishwasher, dryer, or hot water as these
may cause deformation.
28
Tank Cap
Lid
Water Tank
Tank
Packing
Tank Pipe
Cap
Impeller
Cap Lid
Holder
Chlorine-Cleaning Filter
Wash while pressing on it gently.
* Do not use bleach or detergent.
Doing so may cause odors in the
ice.
6
Assembling the water supply pump
1 Fit the chlorine-cleaning
filter into the cap.
* The chlorine-cleaning filter
does not have a front side or
back side.
2 Fit the cap lid onto
the cap.
3 Install the impeller
into the impeller
holder.
4 Rotate the cap and hook the tab (

the projection ( ) on the impeller holder.
Make sure that the impeller is inside.
 
Rotate
5 Rotate the water supply
pump and install it onto
the water tank.
Align the triangle mark on the
bottom of the water tank with
the triangle mark on the cap
lid and push the water supply
pump in securely so there is
no gap.
7
Install the tank pipe, tank packing,
lid, and tank cap.
1 Connect the tank pipe to the water tank
and water supply pump.
Check that there are no foreign substances between
the tank pipe and the water tank, or between the
tank pipe and water supply pump.
Check that there are no
Tank Pipe
foreign substances.
Water Supply Pump
Caution
Do not let
a foreign
substance block
Water Tank
the hole.
2 Install the tank packing.
3 Install the lid.
4 Install the tank cap.
After Assembly
After Assembly
After Assembly

) onto
After Assembly
Water Tank
Rotate
Tank Packing