Messages - Panasonic SC-BTT560 Operating Instructions Manual

Messages

The following messages or service numbers may
appear on the TV or unit's display.
On the television
Cannot play.
You inserted an incompatible disc.
Cannot play on this unit.
You tried to play a non-compatible image.
Confirm "SD" on the unit's display is not
displayed and re-insert the card.
No disc inserted.
The disc may be upside down.
$ This operation is not available.
Some operations are unsupported by the unit.
(For example, reverse slow-motion, etc.)
IP address is not set.
The "IP Address" in "IP Address / DNS
Settings" is "---. ---. ---. ---". Set the "IP
Address", "Subnet Mask", and "Gateway
Address". (Select the automatic address
acquisition if necessary.)
The wireless access point currently has a low
network security setting. It is recommended to
change to a higher setting.
Set a stronger network security level referring
to the wireless router operating instructions.
50
VQT4Q16
On the unit's display
F99
The unit fails to operate properly. Press [Í/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
NET
While connecting to a network.
No PLAY
There is a viewing restriction on a BD-Video
or DVD-Video. (
No READ
The media is dirty or badly scratched. The
unit cannot play.
PLEASE WAIT
The unit is carrying out internal process. This
is not a malfunction. You cannot operate the
unit while "PLEASE WAIT" is displayed.
REMOVE
The USB device is drawing too much power.
Remove the USB device.
SET
(" " stands for a number.)
The remote control and main unit are using
different codes. Change the code on the
remote control.
Press and hold [OK]
and the indicated
number button at the
same time for more
than 5 seconds.
U59
The unit is hot.
The unit switches to standby for safety
reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when
installing the unit.
41)