Biketec AG Flyer Operating Manual page 5

5. After switching on, the middle level of
support is always turned on. By pressing the
"Mode" button, you can set how strong the mo-
tor support should be. Every push of the button
switches the support one lever higher. When
the highest possible support has been reached,
pressing the "Mode" button again switches
back to the weakest level of support.
POWER
Power
EF
km/h
5
STANDARD
Assist
km/h
AV
Mode
6. If you have a FLYER with an LCD control
panel, press the "Power" button.
Ensure that you do not place your feet on the
pedals while switching the motor on or during
the two seconds subsequent to this.
The strength of the motor support is regulated
here by pressing both the "Assist" buttons. If
you would like stronger support, press the up-
per of the two buttons, with the arrow point-
ing upwards/forwards. By pressing the lower
"Assist" button, the support is reduced. Every
time you press one of these buttons, the level
of support changes by one step.
2 sec.
Power
Assist
7. Apply at least one of the brakes before
placing your feet on the pedals. As soon as you
start to pedal, the motor will start supporting
you. This is helpful in getting going and on up-
hill routes, but this can also lead to uncertainty
3
and serious falls when it is unfamiliar.
POWER
EF
km/h
5
3
STANDARD
km/h
AV
Mode
Power
EF
STANDARD
Assist
Mode
1
2
Now you can start riding!
POWER
km/h
5
3
km/h
AV
2 sec.