Biketec AG Flyer Operating Manual page 29

Battery charge level display
Display (after
Battery charge
2 seconds)
3 LEDs lit *** 70-100 %
2 LEDs lit ** 40-70 %
1 LED lit * 10-40 %
< 10%
Now you will
1 LED slowly
start to notice
flashing °
a slight loss of
performance.
- 0%
1 LED quickly The system will
flashing ° soon switch
itself off.
Please ensure that while switching on the bicy-
cle as well as two seconds subsequent to this,
you do not place a foot on either of the pedals.
The sensor in the motor is adjusted
afresh every time it is switched on. It should
not be subjected to any force during these
two seconds.
Hi
Lo
Mode
Power
Automatic switch off
If your FLYER does not move
for ten minutes after stopping,
the system turns off automatically. If you
would like to ride with support once more,
you have to press the "Power" button on
the screen once again.
2 sec.
25