Biketec AG Flyer Operating Manual page 28

24 The display panel
10. The display panel
10.1 LED display panel unlit
The display panel on the handlebars has four
buttons and various display features.
Hi
Lo
Mode
Power
In the middle of the panel is the on/off "Power"
button (orange).
This is used to switch the support on and
off.
On the left hand side, you will find both
"Mode" buttons (arrow up, arrow down). These
buttons are used to regulate the strength of
the motor support.
To the right next to these are the LEDs,
which show you the strength of the support
The upper LED (HI)
Strongest support
represents 150 or 200% of
your pedal force depending
on the model
currently being provided. After switching the
motor on, the middle support level is always
on. By pressing one of the "Mode" buttons,
you can select how strong the motor support
should be. Every press of the buttons switches
the support up or down one level, depending
on which button you apply. Every level of sup-
port can be applied by only pressing one of the
"Mode" buttons until you reach the desired
level of support.
Mode
The middle LED The lower LED (Lo)
Middle support Weakest support
represents 100 - 130% of represents 50 - 70% of your
your pedal force depend- pedal force depending on the
ing on the model model
The LEDs for dis-
playing the charge
level of the battery
are located in the
bottom right.
The "Light" button
Mode
is located in the top
right. For enhancing
your safety, we rec-
ommend riding with
lights on
Power
You can also use
Hi
the lights irrespective
of any motor support
If you turn off the motor support, the light
also turns itself off. However, you can switch it
Lo
on irrespective of any motor support.
The LEDs for displaying the charge level of
the battery are located in the bottom right.
Power
Hi
Lo