Height Of The Handlebars - Biketec AG Flyer Operating Manual

16 Adjusting the bike to the rider

7.5 Height of the handlebars

When the seat has been securely and comfort-
ably positioned, the handlebars have to be set
to your requirements. Please allow a specialist
to do this.
An effective starting position for relaxed
riding is offered by a seating position in which
the upper body and arm form a 90° angle.
In order to change the height of the handle-
bars, the height of the stem has to be adjusted.
90˚
90° arm-upper body angle
Speedlifter
If your FLYER is equipped with a Speedlifter
stem, this can be done in an instant.
You only have to open the quick release lever
and pull the handlebars and stem upwards. When
the handlebars are in the desired position, close
the lever again completely.
The Speedlifter Twist System allows the han-
dlebars to be turned to the side to save space,
e.g. during transport.
Open the quick release lever of the Speed-
lifter Twist by hand. Lift the safety bolt with
your fingers. Now you can twist the handlebars
to the side until the bolt automatically clicks
into its 90° position. Shut the quick release
completely, so that the handlebars are fixed.
When you twist the handlebars back into the
riding position and proceed in reverse order to
the process described above, the safety bolt
will once again click safely into place. Com-
pletely close the quick release, so that the
handlebars are once again secure. That's it!
Ready to ride!