Removing The Unit; Specifications - Sony CDX-GT820IP Operating Instructions Manual

Removing the unit Specifications
Hook facing
inwards.
Power amplifier section
Outputs:
Speaker outputs (sure seal connectors)
Speaker impedance:
4 - 8 ohms
Maximum power output:
52 W x 4 (at 4 ohms)
CEA2006 Standard
Power Output: 17 Watts RMS x 4 at
4 Ohms
<
1% THD+N
SN Ratio: 82 dBA
(reference: 1 Watt into 4 Ohms)
Tuner section
FM
Thning range:
87.5 - 107.9 MHz
Antenna (aerial) terminal:
External antenna (aerial) connector
Intermediate frequency: 10.7 MHzl450 kHz
Usable sensitivity:
9 dBf
Selectivity:
75 dB at 400 kHz
Signal-to-noise ratio:
67 dB (stereo), 69 dB (mono)
Harmonic distortion at 1 kHz:
0.5 % (stereo),
0.3 % (mono)
Separation:
35 dB at 1 kHz
Frequency response:
30 - 15,000 Hz
AM
Thning range:
530 - 1,710 kHz
Antenna (aerial) terminal:
External antenna (aerial) connector
Intermediate frequency: 10.7 MHzl450 kHz
Sensitivity:
30 I.lV
CD Player section
Signal-to-noise ratio:
120 dB
Frequency response:
10 - 20,000 Hz
Wow and flutter:
Below measurable limit
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION
23.2 watts per channel minimum continuous
average power into 4 ohms, 4 channels driven
from 20 Hz to 20 kHz with no more than 5% total
harmonic distortion.
e
Pull the release keys to unseat the unit.
2
Remove the unit.
o
Insert both release keys simultaneously
until they click.
1
Remove the protection collar.
o
Detach the front panel (page 6).
e
Pinch both edges of the protection collar,
then pull it out.
I
22
e
Slide the unit out of the mounting.
General
Outputs:
Audio outputs terminal (front/rear)
Subwoofer output terminal (mono)
Power antenna (aerial) relay control terminal
Power amplifier control terminal
Inputs:
Telephone ATT control terminal
Illumination control terminal
BUS control input terminal
BUS audio input terminal
Remote controller input terminal
Antenna (aerial) input terminal
AUX input jack (stereo mini jack)
iPod signal input terminal (dock connector)