Adjusting Your Monitor Image; Using The Direct Access Controls; Using The On-Screen Display (Osd) Controls - Lenovo LT2423wC User Manual

Adjusting your monitor image

This section describes the user control features used to adjust your monitor image.

Using the direct access controls

The direct access controls can be used when the On Screen Display (OSD) is not
displayed.
Table 2-1. Direct access controls
Icon
To use other direct access controls:
1. Press and hold
adjustments to the OSD. Press
allow adjustments to the OSD.
2. Enables DDC/CI by default. Use OSD Exit Key, Press and hold the
for 10 seconds to disable / enable DDC/CI function. The words " DDC/CI
Disable" or "DDC/CI Enable" will be displayed.

Using the On-Screen Display (OSD) controls

The settings adjustable with the user controls are viewed through the On-Screen
Display (OSD), as shown below.
To use the controls:
1. Press
2. Use or
function. If there is a sub-menu, you can move between options using
then press
save.
3. Press
Control
Image Setup
Brightness
Volume
for 10 seconds to lock the OSD. This will prevent accidental
Brightness/Contrast
to open the main OSD menu.
to move among the icons. Select an icon and press
to select that function. Use
to move backwards through the sub-menus and exit from the OSD.
Description
Activates automatic image adjustment.
Direct access to Brightness adjustment.
Adjust the volume.
and hold for 10 seconds to unlock the OSD and
or
Chapter 2. Adjusting and using your monitor
to access that
to make adjustments. Press
button
or ,
to
2-3