Kenwood KDC-BT838U Instruction Manual page 40

Protect:
Troubleshooting Guide
Bluetooth audio source
D
The Bluetooth audio player cannot be registered
(pairing).
tI'
The PIN code is fixed.
~
When a PIN code is specified in the Instruction
Manual for Bluetooth Audio Player, register it
with reference to <Registering PIN Code> (page
24) to register the Bluetooth audio player. If no
PIN code is specified in the Instruction Manual,
try"OOOO".
--------------------------------
D
The sound from the Bluetooth audio player is
discontinuous.
tI'
The distance between this unit and audio player is
too far.
......
~
...
fy:l5?~~
__
~~_~_9..~_<?_igJ?!9Y.~!:_~~_~!.~~. to this unit.
tI'
Another Bluetooth device is affecting the Bluetooth
communication.
- Turn off another Bluetooth device.
- Move another Bluetooth device away from this
unit.
"V'"iinother-Biuetooth-CiE;';ice-or"profile is used for
communication.
.w
The downloading of the Phone book or the SMS
disconnects the sound.
40
I
KDC-BT838U
The messages shown below display your
systems condition.
TOC Error: • No disc has been loaded in the disc
magazine.
• The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
Error 05: The disc is unreadable.
Error 77: The unit is malfunctioning for some reason.
¢
Press the reset button on the unit. If the
"Error 77" code does not disappear, consult
your nearest service center.
Mecha Error: Something is wrong with the disc magazine.
Or the unit is malfunctioning for some reason .
¢
Check the disc magazine. And then press
the reset button on the unit. If the "Mecha
Error" code does not disappear, consult
your nearest service center.
IN (Blink): The CD player section is not operating
properly.
¢
Reinsert the CD. If the CD cannot be
ejected or the display continues to flash
even when the CD has been properly
reinserted, please switch off the power
and consult your nearest service center.
The speaker wire has a short-circuit or
touches the chassis of the vehicle, and then
the protection function is activated.
¢
Wire or insulate the speaker cable properly
and press the reset button. If the "Protect"
code does not disappear, consult your
nearest service center.
Unsupported File:
An Audio file is played with a format that this
unit can't support.
Copy Protection:
A copy-protected file is played.
Read Error: The file system of the connected USB device
is broken.
¢
Copy the files and folders for the USB
device again. If the error message is still
displayed, initialize the USB device or use
other USB devices.
No Device: The USB device is selected as a source
although no USB device is connected.
¢
Change the source to any source other
than USB. Connect an USB device, and
change the source to USB again.
NIA Device: An unsupported USB device is connected.
No Music Datal Error 15:
• The connected USB device contains no
playable audio file.
• Media was played that does not have data
recorded that the unit can play.