JVC KW·ADV792 Instructions Manual page 17

Select to apply the effect to multi-channel encoded
software.
Select to always use this function.
• On
You can enjoy apowerful sound at alow volume level while playing Dolby Digital
software.
• Auto
When playing back amulti-channel disc, this setting affects the signals
reproduced through the LINE OUT jacks.
• Dolby Surr.
Select this to enjoy multi-channel surround audio by
connecting an amplifier compatible with Dolby Surround.
• Stereo Normally select this.
D. (Dynamic)
Range Compres.
(Compression) *9
Down Mix*9
Menu item:
• Wide
• Auto
IF Band Width Increases the tuner selectivity to reduce interference noises
between adjacent stations. (Stereo effect may be lost.)
Subject to the interference from adjacent stations, but
sound quality will not be degraded and the stereo effect
!I!It-
t -
w_i_lI_re_m_ai_n. _
..
~
Area Setting
=
t o-
• US
• Europe
• SA
When using in North/Central/South America. FM/AM
intervals are set to 200 kHz/10kHz.
When using in any other areas. FM/AM intervals are set to
50 kHz (100 kHz during auto search)/9 kHz.
: When using in South American countries where FM interval
is 100 kHz. AM interval is set to 10kHz.
Sirius ID *10
Your SIRIUS identification number appears on the monitor.
AV Input*ll
-
=
~
c
You can determine the use of LINE IN and VIDEO IN jacks.
(~
47)
• Off Select when no component is connected ("AV-IN" is
skipped while selecting the source).
• iPod (Off) Select when connecting the iPod/iPhone using the USB
Audio and Video cable for iPod/iPhone.
(~
45)
• Audio&Video Select when connecting an AV component such as aVCR.
• Audio Select when connecting an audio component such as a
portable audio player.
• Camera *12
Select when connecting arear view camera to display the
picture (as it is taken).
• Navigation
Select when connecting aNavigation System.
(~
47)
*9
Selectable only for "DISC/USB." (Playback stops when you change the setting.)
*10
Appears only when aSIRIUS Satellite Radio is connected.
*11
Not selectable when "AV-IN" is selected as the source.
*12
The REVERSE GEAR SIGNAL lead connection is reqUired. See Installation/(onnection Manual. The rear view through
the camera appears on the screen in <Full> aspect ratio (regardless ofthe aspect ratio setting) when you shift the
gear to the reverse (R) position. When you press DISP on the monitorpanel, or when you shift the gear to another
position other than the reverse (R) position, the rear view screen is cleared.
(ontinued on the next page
AV MENU
17