Table of Contents
Advertisement
TROUBLE SHOOTING
TROUBLE
Flasher lights, brake light, horn
and multi-functional digital
speedometer fail
Time is not displayed or not cor-
rectly displayed
The battery is discharged
No values are visible in the
multi-functional digital
speedometer display.
The speed indication on the
multifunctional digital
speedometer is not working
The blink code (FI indicator lamp) indicates which component is affected by an error. This allows the error to be identified if no diagnosis
tool is available. The rhythm of the blinking lamp will let you determine the two-digit „blink code",
e.g.:
Blink code 34: FI blinks 3x long, 4x short, pause,
BLINK CODE
SIGNAL / COMPONENT
02
Pulse generator
06
Throttle sensor
07
Sensor for 2nd throttle valve
09
Intake manifold air pressure for sensor rear cylinder
11
Intake manifold air pressure sensor for front cylinder
»
CAUSE
Bulb burned out
Blown fuse
Blown fuse, thus no continuous
power supply
The ignition (power consumer) has-
n't been switched off
The battery isn't charged by the
generator
Blown fuse
Pickup cable is damaged or con-
tacts on the cable connector have
oxidized
REMEDY
Replace bulb
Replace fuse HORN BRAKELIGHT SPEEDO.
Replace fuse ACC 1 / CLOCK and set the clock.
Recharge the battery according to the relevant instructions.
Voltage regulator and generator should be checked by an
authorized KTM workshop.
Replace fuse HORN BRAKELIGHT SPEEDO.
Check the pickup cable for damage, visit an authorized KTM
workshop
Blink code 06: FI blinks 6x short, pause
ERROR DESCRIPTION
Malfunction
Output signal too low /high
Output signal too low /high
Output signal too low /high
Output signal too low /high
86
ENGINE
Stalls
Continues to run
Continues to run
Continues to run
Continues to run
Hide quick links:
Advertisement
Table of Contents
