IBM BladeCenter S Installation And User Manual page 56

Procedure
1. Read Safety and "Handling static-sensitive devices" on page 26.
2. Slide the module into the fan module bay until the fan handle locks.
Installing an I/O module
To install an I/O module, open the release handle, slide the module into the I/O
module bay of the BladeCenter S chassis. Before installing an I/O module, read
any installation instructions that comes with that I/O module.
Before you begin
About this task
Note:
You can find the documentation for I/O modules at the IBM Systems Information
Center, which is at http://publib.boulder.ibm.com/infocenter/systems/index.jsp.
To access the I/O module documentation from this site, click Systems hardware >
BladeCenter information > I/O modules.
To determine which I/O modules are compatible with the BladeCenter S chassis,
see the IBM ServerProven Web site at http://www.ibm.com/servers/eserver/
serverproven/compat/us/eserver.html.
Procedure
1. Read Safety and "Handling static-sensitive devices" on page 26.
2. Open the release handle (rotate the handle down).
3. Slide the module into the module bay until it stops.
4. Close the release handle (rotate the handle up).
44
BladeCenter S Type 7779/8886: Installation and User's Guide
Module
filler
I/O
module
Release
handle
(open)