IBM BladeCenter S Installation And User Manual page 51

Drive
cage
filler
Drive-tray
assembly
Drive
handle
Graphic illustrating the installation of a 12-disk storage module
Procedure
1. Read Safety and "Handling static-sensitive devices" on page 26.
2. Open the release handles on the disk storage module (rotate the top handle up
and the bottom handle down).
3. Slide the disk storage module into the disk storage module bay until it stops.
4. Close the release handles (rotate the top handle down and the bottom handle
up).
5. Install hard disk drives:
a. Open the release handle on the hard disk drive (rotate the handle up).
b. Slide the hard disk drive into the disk storage module until it stops.
Important: The drive bay that you use is determined by the SAS
connectivity module zoning configuration that you have selected for the
BladeCenter S system.
Filler
panel
Chapter 2. Installing the BladeCenter S Types 7779 and 8886
39