Synology DiskStation User Manual page 21


Join a wireless network: The wizard will scan available wireless access points or Ad-Hoc networks with their
signal strength and security status. If the access point you want to access is locked with password protection,
the wizard will ask you to enter the password.

Connect to a hidden wireless
privacy reason, it will not be discovered during the scanning. You can manually connect to those hidden
access points by entering the required information manually.

Create an Ad-Hoc Network: In addition to infrastructure network, in which a central access point (AP) bridges
the wireless network to a wired Ethernet network, Ad-Hoc network is also widely used. In an Ad-Hoc network,
all wireless devices within range of each other can communicate in a peer-to-peer fashion without a central
access point. To set up an Ad-Hoc network, all wireless devices have to be configured for Ad-Hoc mode
instead of the infrastructure mode.
Note: For a list of compatible wireless dongles, visit www.synology.com.
IPv6 Setup
When you are configuring the
IPv6 settings.
Synology DiskStation supports IPv4/IPv6 dual stack scheme. This means that both IPv4 and IPv6 can work
simultaneously on Synology DiskStation. The default setting for IPv6 is Auto.
On the IPv6 Setup page, choose between the different setup types:
 Auto: DiskStation will automatically generate a local IPv6 address. This is generated based on DiskStation's
MAC address.
 DHCP: DiskStation will automatically get an IPv6 address from the DHCP server which supports IPv6.
 Manual: Set up IPv6 manually by entering
 Off: Disable IPv6 support.
Note: If you want to join an IPv4 network environment with IPv6 address, you need to enable IPv6 Tunnel. See the
section below for more information.
PPPoE
Click the PPPoE on the left side if your Synology DiskStation is connecting to a DSL or cable modem, and your
Internet Service Provider (ISP) uses PPPoE (Point to Point Protocol over Ethernet).
To connect to the Internet via PPPoE:
1 Click PPPoE Setting.
2 Enter the account information provided by your ISP.
3 Click OK.
Note: If you are still facing connection problems, contact your Internet Service Provider.
2
Hotspot
If there is a wireless dongle
your DiskStation to turn it into a wireless access point that can share its wireless connection with computers or
mobile devices within the range of the Wi-Fi network.
To enable Hotspot on your DiskStation:
1 Click the WiFi Setup button.
2 Select Wireles Hotspot, and then click OK.
3 Specify the SSID, the wireless mode and width, and the transmit power for your Wi-Fi network.
---------
1
IPv6 service is only supported on 08-series models or later (excluding 108j, 109j).
2
Hotspot is only supported on specific models only.
3
For a complete list of supported wireless dongles, visit www.synology.com.
21 Chapter 3: Modify System Settings
network: If an access point doesn't broadcast its SSID (Network Name) for
LAN or Wireless Network
IPv6 address,
3
connected to the USB port of your Synology DiskStation, you can enable hotspot on
Synology DiskStation User's Guide
interface, click the IPv6 Setup
1
Prefix length, and Default
Based on DSM 4.1
button to change the
gateway.