Alto PM-8 DRAGONFLY User Manual page 11

4.7 AUX SEND
These two controls are used to adjust the level of the signal sent to AUX
buses, and their adjustable range goes from -
AUX1 is configured as PRE-FADER, so, generally, it can be used for
monitor application.
While AUX2 is configured as POST-FADER, therefore, most of the times,
it will be used for effects and processors input, however, you can also
change it to PRE-FADER configuration according to the specific appli-
cation. (For more detail, please refer to chapter 6.)
In this typical compact unit, excluding sending out directly to the external
effect or processor equipment, AUX SEND2 will also be sent to the
internal onboard effect module.
4.8 PAN 11
This is the PANORAMA control, or balance control. You can adjust
the stereo image of the signal via this Control. Keep this control in
center position and your signal will be positioned in the middle of
stage. Turn this control fully counterclockwise and the signal will be
present only on the left speaker and vice-versa. Of course a wide
number of intermediate positions is available.
4.9 PEAK 12
Inside your PM-8 DRAGONFLY the audio signal is monitored in several
different stages and then sent to the PEAK Led. When this Led blinks,
it warns you that you are reaching signal saturation and possible dist-
ortion. The PEAK Led will blink with a level that is 6dB before actual
clipping.
4.10 LEVEL 13
This Control will adjust the overall level of this channel and set the
amount of signal sent to the Main output.
10
to +15dB.
10
0
EQ
HI
12kHz
-15 -15 +15 +15
0
MID
2.5kHz
-12 +12
0
LOW
80Hz
-15 -15 +15 +15
0
1 AUX
PRE
10 1
- +15
0
2
/
POST
D
(PRE)
F
X
- +15
PAN
11
LEFT RIGHT
12
0
PEAK
13
- +10
LEVEL