Rear Panel - Alto PM-8 DRAGONFLY User Manual

- 2-TRACK IN/OUT
Input
Use the Tape input if you wish to listen to your Mix from a Tape Recorder or DAT, you can assign the signal coming
from the Tape Recorder either to a pair of studio monitor using the Control Room assignment on the front panel or
directly to the Main Mix.
Output
These 1/4" TRS sockets will route the main mix into a tape recorder.
- 2TK IN
This control is used to adjust the level of 2TK IN.
- POWER AMP
This switch is used to turn ON or OFF the built-in power amplifier.
- MAIN MIX OUTPUT
These stereo outputs are supplied with 1/4" jack sockets and con-
trolled by the Main Mix Level. The output level can be varied from
- to +10dB.
- CONTROL ROOM OUTPUT
These 1/4" phone sockets will be used to send the signal to Studio Monitor speakers or to a second set of PA.

4.12 REAR PANEL

36
RIGHT LEFT
SPEAKERS
THIS CONNECTION
FOR ALTO
POWER SUPPLY ONLY!
POWER IN
35
- POWER IN
Used to connect the power supply box.
Note:This connection is for Alto power supply box only!
- SPEAKER OUTPUT
These 1/4" phone sockets are used to connect passive speakers directly, only these output signals through
SPEAKER OUTPUT sockets are amplified by built-in power amplifier.
- PHANTOM
This switch will apply +18 Volt Phantom Power only to the 5 XLR microphone Inputs. When these XLR sockets are
connected with devices that do not require Phantom Power, please make sure the Phantom Power is turned off,
otherwise, this may damage the device and mixer.
30
31
32
33
34
TIP
SLEEVE
DYNADYNAMIC POWER: 2 480W @4
35
36
37
32
37
ON OFF
PHANTOM
WARNING: SHOCK HAZARD DO NOT OPEN
MODEL
AVIS: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING
SERIAL
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
13
POWER AMP
OFF ON
C.R MAIN MIX
OUTPUT OUTPUT
LEFT LEFT
RIGHT RIGHT
34 33
CAUTION CAUTION
RISK OF ELECTRIC SHOCK RISK OF ELECTRIC SHOCK
DO NOT OPEN DO NOT OPEN