Pride Mobility JET 7 Owner's Manual page 35

I X . C A R E
Daily Checks
! With the controller turned off, check the joystick. Make sure it is not bent or damaged and that it returns to the centre
position when you release it. Check the rubber boot around the base of the joystick for damage. Visually inspect the
boot only. Do not handle it or try to repair it. See your authorised Pride Dealer if there is a problem.
! Visually inspect the controller and charger harnesses. Make sure that they are not frayed, cut or have any wires
exposed. See your authorised Pride Dealer if there is a problem with any of these harnesses.
Weekly Checks
! Disconnect and inspect the controller and charger harnesses from the electronics tray. Look for corrosion. Contact
your authorised Pride Dealer if necessary.
! Ensure that all parts of the controller system are securely fastened to your power chair. Do not overtighten any screws.
! Check the tyres for excessive wear or a wobble.
! Check for proper tyre inflation. There should be 2.4 bar (35 psi) in each tyre. If a tyre will not hold air, see your
authorised Pride Dealer for replacement of the tube.
! Check the brakes. This test should be carried out on a level surface with at least 1 metre (3 feet) of clearance around
your power chair.
To check the brakes:
1. Turn on the controller and turn down the speed adjustment to a slow setting.
2. After one second, check the battery condition meter. Make sure that it remains on.
3. Slowly push the joystick forward until you hear the electromagnetic brakes click. Immediately release the joystick.
Repeat this test three more times, pushing the joystick rearwards, left and right. You must be able to hear each
electromagnetic brake operating within a few seconds of joystick movement.
NOTE: The power chair may move when performing this test. Immediately release the joystick if this occurs.
Monthly Checks
! Check that the anti-tip wheels do not rub the ground when you are operating your power chair; adjust them as
necessary. See VI. "Comfort Adjustments."
! Check for extreme wear on the anti-tip wheels. Replace them as necessary.
! Check for drive tyre wear. See an authorised Pride Dealer for repair.
! Check the rear castor wheels for wear. Replace as necessary.
! Check the rear forks for damage or fluttering which indicates that they may need to be adjusted or the bearings may
need to be replaced. See an authorised Pride Dealer for repair.
! Keep your power chair clean and free of foreign material such as hair, food and drink.
Yearly Checks
Take your power chair to an authorised Pride Dealer for yearly maintenance. This helps to ensure that your power chair is
functioning properly and helps prevent future complications.
Storage
Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries
from your power chair. See VIII. "Batteries and Charging."
WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be
damaged.
Jet 7
A N D M A I N T E N A N C E
www.pridemobility.com 35