Pride Mobility JET 7 Owner's Manual page 23

V I . C O M F O R T
Seat Position
You can move the seat forward or rearward by changing the
extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Disconnect the controller from the electronics tray.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of mounting holes.
You must move both extrusions the same number of holes
either forward or rearward. See figure 22.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Connect the controller to the electronics tray.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback, you
can adjust it to four (4) different angles: 90°, 102°, 105° or 107°.
To adjust the seatback angle:
1. Remove the adjustment screw from each seat hinge. See
figure 23.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screw to each seat hinge and tighten.
Armrest Height
To change the armrest height:
1. Loosen the setscrew at the rear of each armrest.
2. Slide the armrests up or down to the desired height.
3. Tighten the setscrews.
Armrest Width
To change the armrest width:
1. Loosen the two armrest knobs on the armrest receiver
bracket. See figure 23.
2. Slide the armrests in or out to the desired width.
3. Tighten the knobs.
Armrest Angle
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Loosen the locking nuts. See figure 23.
3. Turn the adjustment screw clockwise to lower the front of the
armrest and anticlockwise to raise the front of the armrest.
4. Tighten the locking nuts to secure the adjustment screw.
Jet 7
A D J U S T M E N T S
Figure 22. Seat Mounting Holes
LOCKING
NUTS
SEATBACK ANGLE
ADJUSTMENT
SCREW
ARMREST KNOB
Figure 23. Seatback Angle Adjustment
www.pridemobility.com
ARMREST ANGLE
ADJUSTMENT
SCREW
23