Displaying The Picture - Hitachi CP-X2010 User Manual – Operating Manual

Ofrecido por www.electromanuales.com

Displaying the picture

1. Activate your signal source. Turn the signal
source on, and make it send the signal to
the projector.
2. Use the VOLUME + / VOLUME - buttons
to adjust the volume.
To have the projector silent, press the MUTE
button on the remote control.
3. Press the INPUT button on the projector.
Each time you press the button, the
projector switches its input port in turn.
You can also use the remote control to
select an input signal. Press the VIDEO
button for selecting an input signal from the
COMPONENT (Y, Cb/Pb, Cr/
or VIDEO port, or the COMPUTER button
for selecting an input signal from the
COMPUTER IN1 or COMPUTER IN2 port.
4. Press the ASPECT button on the remote
control. Each time you press the button,
the projector switches the mode for aspect
ratio in turn.
Use the zoom ring to adjust the screen
5.
size.
Use the focus ring to focus the picture.
6.
CAUTION
other method of blocking the projection light, such as attaching something to
the lens or placing something in front of the lens, may cause the damage to the
projector.
NOTE The ASPECT button does not work when no proper signal is inputted.
in the CD.
10
ON
OFF
KEYSTONE
POSITION
INPUT button
, S-VIDEO
ON
OFF
KEYSTONE
POSITION
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
VOLUME+ button
DOWN
VOLUME- button
MY BUTTON MUTE
1 2 MUTE button
MENU
ENTER
ESC RESET
VIDEO button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
COMPUTER button
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ASPECT button
DOWN
MY BUTTON MUTE
1 2
MENU
ENTER
ESC RESET
Zoom ring