4-Button Transmitter Configuration; Optional Radar Master Transmitter; Arm/Disarm Diagnostics - Clifford Matrix 1 Installation Manual

4-Button Transmitter Configuration

This system has a 4-button transmitter configuration that can be used when upgrading to an
optional 4-button remote. This configuration can be programmed to a 4-button transmitter using
Channel 8 of the Transmitter/Receiver Learn Routine. In the 4-button transmitter configuration,
the buttons are assigned to the following functions:

Optional Radar Master Transmitter

Separate transmitter button arming/disarming/panic (Channels 4-6, see channel chart in
Transmitter/Receiver Learn Routine section) can only be utilized when upgrading to an optional
Radar Master transmitter. When using a Radar Master transmitter with this system, Channels 4-6
may be programmed to the transmitter in a variety of configurations.
Diagnostics
The system's microprocessor monitors and reports all active and violated zones when arming and
disarming. LED flashes indicate the active or violated zone; siren chirps indicate system status.

Arm/Disarm Diagnostics

The number of siren chirps will indicate the status of the alarm when arming and disarming. For
information on which zone is active or has been violated refer to the Table of Zones.
www.clifford.com
..........................operates ......................Arm/Disarm/Panic
.............................operates ......................Channel 2
.............................operates ......................Channel 3
..........................operates ......................Arm/Disarm/Panic
.............................operates ......................Channel 2
.............................operates ......................Channel 3
...............................is ...........................Unassigned
25