TOTALINE P374-1800 Owner's Manual page 70

How to Set and Reset the UV Light How to Set and Reset the UV Light
Run-Time Alarm Run-Time Alarm
This counter keeps track of the number of days since the UV Light
counter has been reset. The UV Light icon will appear after the
number of days has been achieved, as shown in step #29 (below).
Setting the counter to zero in Step #29 will prevent the Service UV
Light icon from ever appearing.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
Days since the UV Light
icon has been reset
Press
Reset the counter to 0 to
remove the Service UV
Light icon from the display.
FAN
16
Press the MODE button repeatedly
MODE
until this setup screen appears.
Adjust the number of days
in increments of 10 before
the UV Light icon appears
on the display. 0 = off.
(0 - 1990 days)
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
I4
0
Setup
Service
UV Light
29
0
Setup
Service
UV Light
Page 16.3
TOTALINE
MODE
MODE
Press
PROGRAM