Energy Save Operation - TOTALINE P374-1800 Owner's Manual

SECTION 15

Energy Save Operation

Energy Save Operation
How to Use the Energy Save Feature How to Use the Energy Save Feature
If the thermostat is configured to be programmable (Section 4), and
Energy Save has been selected in step #26 (below), the room will
attempt to reach the selected comfort temperature at the exact time
programmed into the thermostat. Energy Save only works when the
thermostat enters the Morning mode from the Night mode.
For example, if the Night program is set for 11pm at 65°F heating and
85°F cooling, and the Morning program is set for 6am at 72°F heating
and 75°F cooling, the thermostat will turn the system on before 6am in
an effort to bring the temperature to its correct setting at exactly 6am.
The P374-1800 learns from experience, so please allow 4-8 days
after a program change or after initial installation to give Energy Save
time to adjust to local weather, the construction of your home, and
your heating and cooling system.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
On
Select Energy Save
on or off.
Off
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
26
Setup
OFF
Page 15.1
TOTALINE
MODE
MODE
15
Press
PROGRAM