Adjusting The Dehumidification Setpoint - TOTALINE P374-1800 Owner's Manual

Adjusting the Dehumidification Setpoint

Adjusting the Dehumidification Setpoint
If your HVAC unit is equipped with a dehumidification terminal
Humidity Module has been installed,
to the appropriate terminal on the backplate of the thermostat when
the humidity in the home is above the setpoint you have chosen.
When the indoor humidity rises above the setpoint you have selected,
the appropriate terminal will be de-energized (see page 10.5). The
value for this setpoint ranges from 25% to 99%.
NOTE: Due to variations in environmental conditions, it is not always possible
to achieve the desired humidification or dehumidification setpoint.
Press the HUMIDITY button
HUMIDITY
to enter the Humidification
10
Setup screens.
Press the MODE button once
MODE
Current Room Humidity
+
ON /
Adjust the desired
dehumidification setpoint
(25%-99%)
-
OFF /
Press the HUMIDITY button to leave the Humidity
Control screens (if no buttons are pressed, the display
will leave the Humidity Control screens after 30 seconds).
Dehumidification Notes: Press the
dehumidification setpoint to 99% for no dehumidification operation.
This will lockout Advanced Setup steps 9 and 10 (see page 10.4).
You cannot set the dehumidify setpoint any lower than the humidify setpoint; a
5% differential is forced between the humidify and dehumidify setpoints.
the thermostat will provide power
NOTE: Each step # is located at
the top right corner of the
display for easy reference.
2
40
99
Setup
DeHumidify
button to set the
Page 10.3
TOTALINE
and the
Press
HUMIDITY