Check Power Supply Voltages; Replace Lamps; Recalibrate Scanner - Scan-Graphics CF Series Maintenance Manual

Scanner maintenance manual
Table of Contents

Advertisement

4.3.2 Check Power Supply Voltages

Open the front of the scanner cabinet, refer to the Figure of the Power Supply Assembly found in
this manual and Section 6.7, and check the voltages at the test points on the power supply.

4.3.3 Replace Lamps

To assure adequate and consistent illumination of the document, replacement of the lamp
annually is recommended. Depending on the amount of usage, however, replacement may not be
necessary that often. If you decide to keep the lamp in longer, look for darkening around the ends of the
tube. This indicates disintegration of the filament and the lamp should be replaced. The lamp
replacement procedure is covered in Section 6.3.

4.3.4 Recalibrate Scanner

1. Every twelve months, recalibrate the scanner by adjusting the camera system's offset,
exposure, and gain. See Section 5.1.14.
2. Check the line splice and merge and adjust if necessary. See Section 5.1.8.
3. Check the motor speed and adjust if necessary. See Section 5.1.4.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CF Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents