Setup; Document Catch Installation; Environmental Concerns; Site - Scan-Graphics CF Series Maintenance Manual

2.2 Setup

2.2.1 Document Catch Installation

The document catch has three keyhole type slots. Insert the studs on the rear of the
scanner (about an inch above the fan) into the three keyhole slots and push down firmly to seat
them in the slots.

2.2.2 Environmental Concerns

The following conditions must be met to ensure acceptable working conditions for the
scanner:

2.2.2.1 Site

low degree of static electricity.

2.2.2.2 Airflow

proper airflow. Do not place the scanner near a heating panel or vent.

2.2.2.3 Ambient Light

sunlight or bright lights should fall on the unit.

2.2.2.4 Vibration

settings of the cameras to remain unchanged.

2.2.2.5 Temperature

C (64-86 degrees F). The maximum ambient temperature for a non-working scanner
must be between 5 and 40 degrees C (41-104 degrees F).

2.2.2.6 Humidity

2.3 CONNECTIONS

The site has to be relatively dust free. The environment should also generate a
There must be at least one foot of clearance in the rear of the scanner to allow for
In order to keep the light uniform on the document being scanned, no direct
Excessive vibrations in the room should be avoided in order for the delicate
The ambient temperature in the room should average between 18 and 30 degrees
The point of condensation should not be reached in the room.