Connecting An Hdmp" Or Dvi Device To The Hdmi Input - Toshiba Regza 32RV530U Owner's Manual

Connecting an HDMI™ or DVI device
to the HDMI input
OVI device
Note: To ensure that the HOMI or OVI device is reset properly,
it
is recommended that you follow these procedures:
• When turning on your electronic components, turn
on
the
TV first, and then the HOMI or OVI device.
• When turning off your electronic components, turn off the
HDMI or DVI device first, and then the TV.
TV upper back panel
H~:'';;l
'~2a3a
~
To connect a DVI device, you will need:
one HDMI-to-DVI adapter cable (HDMI type A connector)
per DVI device
- For proper operation, the length of an HOMI-to-OVI
adapter cable should not exceed 9.8 ft (3m). The
recommended length is 6.6 ft (2m).
one pair of standard analog audio cables per DVI device
- An HOMI-to-OVI adapter cable transfers video only.
Separate analog audio cables are required (see
illustration).
- See "Setting the HOMI'M audio mode" (lIE page 32).
TV right side panel
TV
u~pper
back
pa~:.lIN ~
Hom.
1
~j
2
~:.3~:.
•
•
• •
To connect an HDMI device, you will need:
one HDMI cable (type A connector) per HDMI device
- For proper operation, it is recommended that you use an
HOMI cable with the HOMI Logo (HOm.).
To display an 1080p/60Hz signal format. you will need
a
Category 2 cable. Conventional HOMI/O VI cable may not
work properly.
HOMI cable transfers both video and audio. Separate
analog audio cables are not required (see illustration).
See "Setting the HOMI'M audio mode" (lIE page 32).
The HDMI input on your TV receives digital audio and
uncompressed digital video from an HDMI source device, or
uncompressed digital video from a DVI (Digital Visual
Interface) source device.
This input is designed to accept HDCP (High-Bandwidth
Digital-Content Protection) program material in digital form
from EIA/CEA-861-D-compliant[l] consumer electronic
devices (such as a set-top box or DVD player with HDMI or
DVIoutput).
The HDMI input can accept and display VGA, SVGA, XGA,
WXGA, SXGA, 480i (60Hz), 480p (60Hz), nop (60Hz),
1080i (60Hz), and 1080p (24Hz/60Hz) signal formats. For
detailed signal specifications, see page 63.
Supported Audio format: Linear PCM, sampling rate 32/44.1/
48 kHz
Note: To connect
a
PC to the HOMI input, see page 19.
HOMI device
[1] EIA/CEA-861-D compliance covers the transmission of
uncompressed digital video with high-bandwidth digital content
protection, which is being standardized for reception of high-
definition video signals. Because this is an evolving technology. it
is possible that some devices may not operate properly with the TV.
To view the HDMI device video:
Select the HDMI 1, HDMI 2, HDMI 3, or HDMI 4 video input
source on the TV.
*
HDMI, the HDMIIogo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LLC.
*
To select the video input source, press INPUT on the remote control
(1& page 21). To program the TV remote control to operate other
devices, see Chapter 3.
I
16