IBM TotalStorage DS4000 FC2-133 Installation And User Manual page 38

10. Carefully install and secure the server cover.
11. Connect the power cables.
12. Turn on all external fibre-channel devices. Then turn on the server. The
Note: This BIOS banner does not display when the adapter is in a server with an
6
IBM TotalStorage DS4000 FC2-133 Dual Port Host Bus Adapter: Installation and User's Guide
triggering for the DS4000 FC2-133. For system specific configuration,
see the documentation that comes with your server, or contact your IBM
technical support representative to determine if your system board
requires configuration.
3. Turn off the peripheral devices. Then turn off the server.
4. Disconnect the power cords.
5. Remove the server cover.
6. Choose a PCI bus-master slot that supports bus mastering. Most system
boards automatically assign an IRQ level and interrupt line. If your system
board does not automatically assign an IRQ level and interrupt line, you must
assign an IRQ level and use interrupt line A for this PCI bus-master slot.
Before you install the adapter into a PCI bus-master slot, note the following
points:
v Some system boards have two kinds of PCI bus slots: master and
subordinate. The DS4000 FC2-133 must be in a PCI bus-master slot.
(Some system boards have PCI bus-master slots that are shared with
on-board devices. The DS4000 FC2-133 does not work in shared PCI
bus-master slots.)
v PCI connectors vary among system board manufacturers. The DS4000
FC2-133 is a 64-bit PCI device that can function in a 32-bit PCI bus-master
slot.
v The DS4000 FC2-133 is designed and tested to operate at PCI bus speeds
up to 66 MHz and PCI-X bus speeds up to 133 MHz.
v PCI and PCI-X slots look the same. If the server contains both PCI and
PCI-X bus-master slots, see the documentation that comes with the server
to determine the slot type.
7. Remove the expansion slot cover. Before you remove the cover, see the
documentation that comes with the server for specific removal instructions.
Attention: If you try to install the DS4000 FC2-133 into a PCI bus-master
slot that does not conform to the PCI specification, you might damage the
DS4000 FC2-133.
8. Align the adapter with the expansion slot. Carefully press it into the PCI
bus-master slot until it is fully seated and secure.
9. Connect one end of an LC-LC fibre-channel cable to one of the optical
interface connectors on the DS4000 FC2-133. Connect the other end of the
cable to a fibre-channel device. You can connect another device to the unused
optical interface connector.
following information is displayed when the server processor architecture is
Intel Architecture 32 bit (IA-32), Intel Extended Memory 64 Technology
(EM64T) or the Advance Micro Devices 64 bit (AMD-64):
QLogic Corporation QLA2312 PCI Fibre Channel ROM BIOS Version X.XX
Copyright (C) QLogic Corporation 1993-2002 All Rights Reserved. www.qlogic.com
Press <Ctrl+Q> for Fast!UTIL BIOS for Adapter 0 is disabled ROM BIOS not installed
Intel 64 bit processor (IA-64) or a Sun SPRAC processor architecture.