Cd Or Dvd Drive Problems - IBM IntelliStation M Pro 9229 Installation Manual

CD or DVD drive problems

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See the parts listing in the Problem Determination and Service Guide to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician)," that step must be performed only by a
trained service technician.
Symptom
The CD or DVD drive is not recognized.
A CD or DVD is not working correctly.
The CD or DVD drive tray is not working.
Action
1. Make sure that:
v The IDE channel to which the CD or DVD drive is attached
(primary) is enabled in the Configuration/Setup Utility program.
v All cables and jumpers are installed correctly.
v The correct device driver is installed for the CD or DVD drive.
2. Run the CD or DVD drive diagnostic programs.
3. Reseat the CD or DVD drive cable.
4. Replace the following components one at a time, in the order
shown, restarting the computer each time:
a. CD or DVD drive
b. CD or DVD drive cable
c. (Trained service technician only) System board
1. Clean the CD or DVD.
2. Run the CD or DVD drive diagnostic programs.
3. Reseat the CD or DVD drive cable.
4. Replace the following components one at a time, in the order
shown, restarting the computer each time:
a. CD or DVD drive
b. CD or DVD drive cable
1. Make sure that the computer is turned on.
2. Insert the end of a straightened paper clip into the manual
tray-release opening.
3. Reseat the CD or DVD drive cable.
4. Replace the following components one at a time, in the order
shown, restarting the computer each time:
a. CD or DVD drive
b. CD or DVD drive cable
Chapter 5. Solving problems
37