IBM TotalStorage DS4000 FC2-133 Installation And User Manual page 42

/V xxxx = Display current version number of BIOS on adapters at address xxxx
/C xxxx = Verify Flash of adapter at address xxxx
/Y xxxx = Display port name of adapter at address xxxx
/L xxxx = Write NOVRAM, adapter address = xxxx
/D xxxx = Copy NOVRAM to file: QL1xNVRM.SAV, adapter address = xxxx
/U xxxx = Update BIOS NOVRAM defaults, adapter address = xxxx
/N <filename.ext> = Use <filename.ext> instead of NVRMxx0.DAT
/T = Multiport Fibre Channel adapter
/X xxxx = Verify NOVRAM of adapter at address xxxx
Note: All of the listed options are supported and you can run them from the
The following list describes examples of additional command-line options that you
can use.
v To write NVRAM on all DS4000 Host Adapters in a system without being
v To save the existing flash code to file QL2312RM.SAV, type:
v To write NVRAM to the adapter at I/O address f400, type:
v To write NVRAM and flash an adapter at I/O address f800, type:
v To write NVRAM and flash all adapters, type:
v To save NVRAM to file QL1xNVRM.SAV, type:
v To update BIOS NVRAM defaults, type:
v To verify NVRAM in all adapters, type:
14
IBM TotalStorage DS4000 FC2-133 Host Bus Adapter: Installation and User's Guide
If no address specified then display the serial number of all adapters
If no address specified then display the BIOS version of all adapters
If no address specified verify the Flash of all adapters
If no address specified, then display port name of all adapters
If no address specified then write NOVRAM to all adapters
If no address specified then write then update all adapters
command line. Options /L, /D, /U, /N, /T, and /X might not display.
prompted for I/O address, type:
flasutil /L
Press Enter.
flasutil /W F600
Press Enter.
flasutil /L f400
Press Enter
flasutil /L f800 /F f800
Press Enter.
flasutil /L /F
Press Enter.
flasutil /D
Press Enter.
flasutil /U
Press Enter.
flasutil /X
Press Enter.