IBM TotalStorage DS4000 FC2-133 Installation And User Manual page 35

assign an IRQ level and use interrupt line A for this PCI bus-master slot.
Before installing your adapter into a PCI bus-master slot, note the following:
v Some system boards have two kinds of PCI bus slots: master and
subordinate. The FC2-133 Adapter must be in a PCI bus-master slot. (Some
system boards have PCI bus-master slots that are shared with on-board
devices. The FC2-133 Adapter does not work in shared PCI bus-master
slots.)
v PCI connectors vary among system board manufacturers. The FC2-133
Adapter is a 64-bit PCI device that can function in a 32-bit PCI bus-master
slot.
v The FC2-133 Adapter is designed and tested to operate at PCI bus speeds
up to 66 MHz and PCI-X bus speeds up to 133 MHz.
v PCI and PCI-X slots look the same. If the server contains both PCI and
PCI-X bus-master slots, refer to the documentation that comes with the
server to determine the slot type.
7. Remove the expansion slot cover. Before you remove the cover, refer to the
documentation that comes with the server for specific removal instructions.
Attention: If you try to install the FC2-133 Adapter into a PCI bus-master
slot that does not conform to the PCI specification, you might damage the
FC2-133 Adapter.
8. Align the adapter with the expansion slot. Carefully press the adapter into the
PCI bus-master slot until it is fully seated and secure.
9. Connect one end of an LC-LC Fibre Channel cable to the optical interface
connector on the FC2-133 Adapter. Connect the other end to a Fibre Channel
device.
10. Carefully install and secure the server cover.
11. Connect the power cables.
12. Turn on all external Fibre Channel devices; then, turn on the server. The
following information is displayed if the server has an Intel 32 bit
processor(IA-32), Intel Extended Memory 64 bit Technology (EM64T)
processor, or an Advance Micro Devices 64 bit (AMD-64) architecture:
Note: This BIOS banner does not display when the adapter is in a server with
an Intel 64 bit processor (IA-64) or a Sun SPRAC processor
architecture.
QLogic Corporation
QLA2312 PCI Fibre Channel ROM BIOS Version X.XX
Copyright (C) QLogic Corporation 1993-2002 All Rights Reserved.
www.qlogic.com
Press <Ctrl+Q> for Fast!UTIL
BIOS for Adapter 0 is disabled
ROM BIOS not installed
To display the Fibre Channel devices, press Ctrl+Q, and then use the Fast!UTIL
program. See Chapter 3, "Configuring the DS4000 FC2-133 with Fast!UTIL," on
page 19 for detailed utility program information.
If the information displayed is not correct and you have checked the adapter
configuration, go to Chapter 5, "Troubleshooting," on page 27 for problem solving
information.
Chapter 1. Preparing and installing the IBM TotalStorage DS4000 FC2-133 Host Bus Adapter
7