Handling Static-Sensitive Devices - IBM TotalStorage DS4000 FC2-133 Installation And User Manual

Figure 2. DS4000 FC2-133 Adapter serial number label

Handling static-sensitive devices

Attention:
avoid damage, keep static-sensitive devices in their static-protective package until
you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v Limit your movement. Movement can cause static electricity to build up around
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed printed circuitry.
v Do not leave the device where others can handle and possibly damage the
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into your system unit
v Take additional care when handling devices during cold weather because heating
Serial number
label
Static electricity can damage electronic devices and your system. To
you.
device.
metal part of the system unit for at least 2 seconds. (This drains static electricity
from the package and from your body.)
without setting it down. If it is necessary to set the device down, place it in its
static-protective package. Do not place the device on your system unit cover or
on a metal table.
reduces indoor humidity and increases static electricity.
Chapter 1. Preparing and installing the IBM TotalStorage DS4000 FC2-133 Host Bus Adapter
3