IBM 80 GB VS160 User Manual page 18

1. Locate an available 5.25-inch bay or space in your computer to mount the tape
2. Attach server mounting rails to the drive (if applicable).
3. Align the drive-bay screw holes with the threaded holes in the drive housing.
4. Insert a screw through each of the drive-bay holes into the threaded holes in
5. If your server requires slide rails, mount the slide rails to the tape drive first,
1-4
80/160 GB VS160 Internal Tape Drive: User's Guide
drive. Remove the cover plate from the bay selected. Install the drive
horizontally or vertically, depending on the bay.
When you mount the tape drive, follow these guidelines:
v Ensure that no objects such as screw heads, cables, or adjacent devices are
pressing against the frame.
v Ensure that nothing blocks the ventilation slots on the bottom and rear of the
tape drive.
Attention: Use only the screws that come with the tape drive. Other screws
might be too long and might damage the drive.
the drive and tighten the screws with a screwdriver.
then slide the assembly into the server.