Attention:
a. Do not connect both the SATA power cable and the tape drive power cable.
If you connect both power cables to the tape drive, you might damage the
tape drive.
b. Do not force the tape drive power cable into the tape drive power connector.
If the tape drive power cable is upside down and you force the connection,
you might damage the tape drive.
5. Connect either the SATA power cable to the SATA power connector, or the tape
drive power cable connector to the four-pin connector on the tape drive as
shown in the previous illustration.
6. Replace the server cover and secure it in place.
7. Reconnect the cables to the server, and then reconnect the power cord to the
server.
Chapter 4. Maintenance and troubleshooting
17