Installing A Tape Drive - IBM 160 GB DLTV4 Installation And User Manual

1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off all attached devices.
3. Turn off the server.
4. Disconnect the power cord.
5. Disconnect all cables from the server and all attached devices, and then open
6. Disconnect the cables from the back of the tape drive.
7. Remove the tape drive mounting screws, and then remove the tape drive from
8. Remove the mounting rails from the tape drive (if applicable).

Installing a tape drive

1. Read the safety information that begins on page v and "Installation guidelines"
Attention:
is wrapped in a static-protective package to prevent damage.
2. Before you open the static-protective package that contains the tape drive,
3. Attach the mounting rails to the tape drive (if applicable).
4. Connect the SATA data cable to the tape drive.
16
160/320 GB DLTV4 Tape Drive: Installation and User's Guide
on page 3.
the server. For information about opening the server, see the documentation
that came with the server.
the server.
on page 3.
Tape drives are sensitive to static electricity discharge. The tape drive
touch the bag to an unpainted metal surface on the server for at least 2
seconds. Remove the tape drive from the static-protective package. If you must
set down the tape drive, place it on the static-protective package. Do not touch
any of the exposed components of the tape drive. Instead, handle it carefully by
the edges.
SATA power
cable
SATA data cable
Tape drive power cable