Helion Criterion HLNA0301 Owner's Manual page 4

PRECAUTIONS WHEN USING THE HRS-3.1 RADIO SYSTEM
• Your model can cause serious damage or injury so please use caution and courtesy when operating your model.
• Do not expose the radio system to water or excessive moisture.
• As a safety precaution, perform all transmitter and receiver adjustments with the vehicle's wheels off the ground. This ensures
the complete control over the vehicle at all times during adjustments.
• Ensure your batteries (both transmitter and vehicle) have been properly charged for use with your model.
• Keep track of the time the system is in use so you will know how long you can safely operate the transmitter batteries.
• Check all servos and electrical connections prior to each run.
• Do not operate your model near traffic, bystanders, parking areas, or any other area that could result in injury to people or dam-
age to property.
• If at any time during the operation of your model you observe any erratic or abnormal behavior of your model, immediately stop
operation and bring the mode to a safe stop in a safe location to diagnose the problem.
• Always power on your transmitter before turning your vehicle on.
• If you have little or no experience operating R/C models, we strongly recommend you seek the assistance of your local hobby
dealer.
R/C models are an extremely fun hobby, but safety should never be ignored or taken lightly. Always take caution when operating
your model as damage to property and injury can result from careless operation. Please consult your local hobby dealer with any
questions or troubleshooting issues. And of course don't forget to have fun, you deserve it after reading through all of these safety
tips!
INTRODUCING THE HRS-3.1 2.4GHz RADIO SYSTEM
Please read and understand the following instructions for your
new radio system prior to operation to ensure the safest and
most enjoyable experience.
Features:
8b
6
5
9
10
4
8a
4
12
7
2
1
11
1. Steering wheel: controls left/right motion (designed to be
operated with right hand).
2. Throttle trigger: controls forward/reverse/brake motion
(designed to be operated with left index finger).
3. Handle: For holding the transmitter (designed to be held with
left hand).
4. Antenna: Transmits signal to the receiver located in the
vehicle.
a. Flip up when transmitter in use. Folded position is only
for storage.
5. ON/OFF Switch: Turns the power ON/OFF for the transmitter
only.
6. Multifunction red Indicator LED:
a. Power indicator
b. Low battery voltage warning, batteries should be re-
placed/recharged before continued use when flashing.
7. REV/Bind:
a. Use to reverse servo/channel operation.
b. Use to put the transmitter into binding mode.
8. Digital Trim: All switches are digital so there is no need to
readjust trim position for different models after initial setup.
a. Steering: Controls the "hands-off" left/right direction of
the vehicle.
b. Throttle: Adjusts the motor speed to STOP when trigger
is in "hands-off" (neutral) position.
9. Dual Rate Adjustment Switch: Adjusts total travel of servo
10. Battery compartment: houses [4] AA batteries for powering
the transmitter. Also has connector for rechargeable NiMH
battery pack.
11. Battery door: Closes the battery compartment, containing
the AA batteries or rechargeable battery pack.
12. Fail Safe setting and Channel 3 toggle.