Gold's Gym 450 User Manual page 9

7. Attach the Latch Insert (70) to the Left Upright (73) with
two M4 x 19mm Screws (1). Make sure that the large
hole in the Latch Insert is on the side shown. Do not
overtighten the Screws.
Located the Latch Pin Assembly (72). Remove the knob
from the pin. Make sure that the collar and the spring
are on the pin as shown. Insert the pin into the Latch
Insert (70), and tighten the knob back onto the pin.
8. Hold the Right Handrail (90) near the Right Upright (78),
and insert the Upright Wire (77) into the opening in the
bottom of the Right Handrail and out of the indicated
hole in the top.
Set the Right Handrail (90) on the Right Upright (78),
and finger tighten three M8 x 19mm Bolts (6) with three
5/16" Star Washers (10) into the Right Handrail and the
Right Upright. Do not fully tighten the Bolts yet. Make
sure that the Upright Wire (77) is not pinched.
Attach the Left Handrail (89) to the Left Upright (73) as
described above. Note: There is no wire harness on the
left side.
9. Have another person hold the Console Base (88) near
the Right Handrail (90). Attach the end of the ground wire
to the indicated small hole in the Right Handrail with the
M4.2 x 13mm Silver Screw (4).
Connect the Upright Wire (77) to the wire harness on the
Console Base (88). See the inset drawing. The connec-
tors should slide together easily and snap into place.
If they do not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Remove the wire tie from the Upright Wire (77).
7
72
Knob
1
Large Hole
8
73
9
77
9
70
73
Collar
Pin
Spring
89
Hole
77
6
10
Wire Tie
6
10
6
78
88
Ground
4
Wire
Small Hole
90
Wire
Tie
77
90
6
10