Maintenance - Reebok RE1M-11700 User Manual

MAINTENANCE

CONT
session at 5-6km?h 3 times a week for two people) lubricate every three to six months. Your may adjust the
timing of the lubrication based on the intensity of the treadmill use level.
To check the lubrication level, simply lift the running belt, and put your hand as far into the center of the belt
as you can reach. If your hand shows signs of silicone, then it does not need additional lubrication. If the
board feels dry and there is very little evidence of silicone on your hand, then additional lubrication should be
added.
TO LUBRICATE THE DECK:
1. Stop the running belt so that the seam is located on top and in the center of the deck.
2.Insert nozzle into spray head of lubricant can.
3.Lift running belt.
4.Position nozzle between the belt and the board approximately 200mm (8" ) from the front of the treadmill.
5.Apply the silicon from the front to the rear of the treadmill on each side of the treadmill. Try to reach the
spray as far into the center of the running deck as possible. The spray time should be approximately four
seconds for each side.
6.Spread the silicon by running the treadmill at 1 Km/H and step gently on the belt from left to right. Do that
for a few minutes and allow the silicon to soak into the belt.
Silicon oil
18