Installation Step By Step; Check List Before Using The Dryer; Preparing To Transport The Dryer Step By Step - Bosch Nexxt premium Operating, Care And Installation Instructions Manual

Installation
step by step
1. Unpack the dryer.
2. Remove all objects from the
drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation location.
5. If required, change the door
hinges to the right
(see page 7).
6. If required install the exhaust air
outlet on the dryer
(see page 37).
7. Have the power supply cord
fitted by an authorized
technician (see page 8).
8. Install exhaust duct, if
necessary.
Follow the installation
instructions supplied by the
appropriate manufacturer!
If space is very restricted, it is
i
recommended to fit the initial
parts of the exhaust duct to the
dryer before the dryer is moved
to its final installation location.
9. Move the dryer to its final
location and align.
d
CAUTION
Do not slide dryer across the
floor if height adjustable feet
have been extended. Feet and/or
dryer base may be damaged if
dryer is slid across floor with
height adjustable feet extended.
10. Position and then level the
dryer .
12
The dryer should be level with
all four feet firmly on the
ground. The dryer must not
wobble. If the dryer is not level
or if it does wobble, the feet
must be adjusted. Adjust the
height adjustable feet until the
dryer does not rock and is level,
both front to back and
side to side.
11. Connect the exhaust duct to
the exhaust air outlet on the
dryer.
12. Insert plug into the wall
receptacle.
d
Check list before
using the dryer
1. Check that steps 1 9 have
been implemented properly.
2. Ensure that the dryer is
connected to the power supply.
3. Read the operating instructions
to understand how your dryer
operates.
4. Conduct an appliance test:
q Check that the drum is
empty.
q Close the dryer door.
q Switch the dryer to Extra
Dry" and then press the
Start button.
q After 3 5 minutes press the
Stop button and open the
door.
5. If the interior of the dryer feels
warm, the dryer has been
connected properly.
Switch the dryer to OFF".
6. If the dryer does not work,
switch the dryer to OFF".
Look in the troubleshooting
section (page 26) of the
OPERATING INSTRUCTIONS
and find the fault.
Preparing to transport
the dryer step
by step
1. Rotate the program selector
to OFF".
2. Pull out power supply plug.
3. Disconnect the exhaust duct
from the exhaust air outlet on
the dryer.
4. Place any accessories in the
drum.
5. Close the door and secure with
adhesive tape.
6. Screw the height adjustable
feet of the dryer into the
housing to prevent them from
being damaged during
transportation.