Installation - Step By Step And Check List - Bosch WTW87NH1UC Use And Care Manual / Installation Instructions

Installation - step by step and check list

Review the following list and check off each step as it is
completed during installation, if necessary.
Unpack the dryer.
1.
Remove all objects from the dryer drum.
2.
Check the dryer for visible damage.
3.
Position the dryer near the installation location.
4.
Disconnect the power cord and drain hose from their
5.
clips on the back of the dryer.
CAUTION
9
Do not disconnect the drain hose from the sump/
pump connection at the bottom of the dryer.
NOTICE: Do not reuse an old or different drain hose.
Only use the drain hose included with the dryer.
Disconnect the drain hose from the right top corner on
6.
the back of the dryer.
Connect the outlet end of the drain hose to a
7.
standpipe or other drain inlet. Examples are shown
below.
CAUTION
9
APPLIANCE DAMAGE COULD OCCUR IF DRAIN
WATER FLOWS BACK INTO THE APPLIANCE
In all drain conditions, scenarios, or connections
you must ensure:
The drain water from the hose is free flowing and
▯
not obstructed allowing adequate water flow.
Drain opening must not be sealed in any way. It
▯
must be open to avoided a back siphon
condition.
The end of the drain hose does not protrude into
▯
the pumped out or standing water.
Be sure to follow all local codes and regulations
▯
in draining the condensate water to a suitable
drain.
Examples of connections:
Plumbing box or Standpipe connection:
▯
For most plumbing box installations (with adjacent
washer) the plastic elbow supplied with the dryer will
not be used and must be removed from the dryer
drain hose.
Fasten the dryer drain hose to the washer drain/elbow
1.
as shown in picture "A". Secure with plastic ties
supplied.
CAUTION
9
Do not over tighten plastic ties pinching or
causing a restriction in the drain hose.
Place drain hose assembly into standpipe as shown in
2.
picture "B".
Sink/Basin or Floor drain:
▯
If using the elbow supplied on the hose re-position
elbow closer to the drain end of hose and fasten with
the plastic ties as shown in picture "C".
15