Installation Step By Step - Bosch MISTCARE Nexxt 500 Series Operating, Care And Installation Instructions Manual

Supplied components
NOTICE
After removing the packaging,
immediately remove any objects
from the drum
.
Useful Tools
The following tools are helpful during
installation:
1. T20 star head screwdriver
2. Philips screwdriver (#2)
3. Flat blade screwdriver
4. Open end wrench 1 in. (25mm)
5. Bubble level
Checklist for Installation
1. Unpack the dryer.
2. Remove all objects from the drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation location (see page 7).
5. If required, change the door hinge
to the left (see page 13).
6. If required, install the side or
bottom exhaust air outlet on the
dryer (see page 13).
7. Have the gas supply connected by
an qualified technician (see page
10).
8. Check for Y" connection, short
hose and AQUASTOP
All manuals and user guides at all-guides.com
included with the dryer packaging
(see page 9).
9. Connect the water supply to the
back of the dryer (see page 8 for
detailed instructions).
10. Install exhaust ductwork if
necessary.
Follow the installation instructions
supplied by the appropriate
ductwork parts manufacturers (see
page 13)
i
If space is very restricted, it is
recommended to fit the initial parts
of the exhaust duct to the dryer
before the dryer is moved to its
final installation location.
11. Move the dryer to its final location.
Do not slide dryer across the
floor if height adjustable feet
have been extended. Feet and/or
dryer base may be damaged if
dryer is slid across floor with
height adjustable feet extended.
12. Position and then level the dryer.
The dryer should be level with all four
feet firmly on the ground. The dryer
must not wobble. If the dryer is not level
or if it does wobble, the feet must be
adjusted. Adjust the height adjustable
feet until the dryer does not rock and is
level, both front to back and

Hose
side to side.
NOTICE
After making preliminary
q
adjustments, press down on each
corner of the dryer to make sure
the unit does not wobble. If it does
wobble, lower the foot on that
corner until the foot touches the
floor firmly.
Install the dryer and level side to side
and front to back. Use a bubble level.
Never remove the height adjustable
feet!
13. Connect the exhaust duct to the
exhaust air outlet on the dryer (see
page 11).
14. Insert the dryer electrical plug into
the wall receptacle (see page 10).
15. Open the shut-off valve.
16. Read the operating instructions to
understand how your dryer
operates. (see page 15).
17. Conduct an appliance test:
q Check that the drum is empty.
q Close the dryer door.
q Switch the dryer to "Extra Dry"
and then press the Start"
button.
q After 3-5 minutes press the
Stop button and open the door.
q If the interior of the dryer feels
warm, the dryer has been
connected properly.
Switch the dryer to "OFF".
q If the dryer does not work,
switch the dryer to "OFF".
Look in the troubleshooting
section (page 25) and find the
fault.
Installation location
d WARNING
DO NOT install the dryer:
- outdoors
- in an environment with dripping
water,
- near flammable materials,
- in rooms which are at risk of frost,
- in rooms which may contain gas
or other fuels,
- in cupboards with lockable doors
or in alcoves.
- with other fuel burning appliances
in the same closet.
7