Optical Drive - HP ProBook 4320s Maintenance And Service Manual

Optical drive

NOTE: All optical drive spare part kits include an optical drive bezel.
Description
Blu-ray ROM with LightScribe DVD±R/RW SuperMulti DL Drive
DVD ±RW SuperMulti Double-Layer Drive with LightScribe
DVD ROM Drive
Before removing the optical drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the switch cover (see
6. Remove the keyboard (see
NOTE:
board, and then rotate it left until it rests upside down on the left side of the computer to remove
the optical drive .
Remove the optical drive:
1. Position the computer with the right side toward you.
2. Remove the Phillips PM2.5×5.0 screw (1) that secures the optical drive to the computer.
3. Insert a flat-bladed screwdriver or similar tool into the access point on the top cover to the optical
drive bracket (2) and press the to the right to release the optical drive from the computer.
Battery on page
Switch cover on page
Keyboard on page
You can release the keyboard without removing the keyboard cable from the system
57).
59).
61)
Component replacement procedures
Spare part number
599538-001
599540-001
599539-001
65