5: Connecting The Antennas; 6: Preparing The Receiver - Sony HT-SF470 Operating Instructions Manual

5: Connecting the
antennas
Connect the supplied AM loop antenna and
FM wire antenna.
Before connecting the antennas, be sure to
disconnect the AC power cord.
FM wire antenna (supplied)
AM loop antenna (supplied)
Notes
• To prevent noise pickup, keep the AM loop
antenna away from the receiver and other
components.
• Be sure to fully extend the FM wire antenna.
• After connecting the FM wire antenna, keep it as
horizontal as possible.
6: Preparing the receiver
Connect the AC power cord to a wall outlet.
AC power cord
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their initial settings.
Be sure to use the buttons on the receiver for
this operation.
r------------------\.
1--
1
~
J
~_J
24 US
I/O
1
Press
1/6
to turn on the
receiver.
2
Hold down
1/6
for a few
seconds until "CLEARED"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.