Enjoying The System's Sound In Another Room - Sony HT-SF470 Operating Instructions Manual

C:L.:c:J.-_-:c::r.-c:::J
Note
Sources with copyright protection may not be
playable on S-AIR products.
Enjoying the system's
sound in another room
AMP
e&--H-- MENU
o
(For the S-AIR receiver only (not
supplied»
You can enjoy the system's sound in another
room by using the S-AIR receiver. The S-AIR
receiver can be placed in another room for
enjoying the system's sound there.
For details of the S-AIR receiver, refer to the
operating instructions supplied with S-AIR
receiver.
G,
+/+/./.
1
Set the 10 of the S-AIR receiver
to match the S-AIR main unit.
e To set the ID of the S-AIR main unit,
see "To set the ID of the S-AIR sub
unit" (page 50).
eTo set the ID of the S-AIR receiver,
refer to the operating instructions
supplied with S-AIR receiver.
Notes
• When you are using another S-AIR sub unit,
such as a surround amplifier, do not change
the ID of the S-AIR main unit. Set the ID of
the S-AIR receiver to match the ID of the
S-AIR main unit.
• When you pair the S-AIR main unit and
another S-AIR sub unit, such as a surround
amplifier, you also need to pair the S-AIR
main unit and the S-AIR receiver. For details,
see "Pairing the S-AIR main unit with a
specific S-AIR sub unit (Pairing operation)"
(page 51).
• For the S-AIR receiver
Refer to the operating instructions
supplied with S-AIR receiver.
8
Pairing completed.
"COMPLETE" appears on the display.
9
Press AMP MENU.
The AMP menu turns off.
• For the surround amplifier
Refer to the operating instructions
supplied with surround amplifier.
5
Press
+'+
repeatedly until
"PA~RING"
appears, then press
G
or •.
6
Press
+,+
repeatedly until the
setting you want appears, then
press
G.
e START: The S-AIR main unit starts
pamng.
e CONDITION: You can check the
current ID. When the pairing setting is
timed out, "NO PAIRING" appears on
the display.
7
Start pairing of the S-AIR sub
unit.
Note
Perform the pairing within several minutes after you
select "START" in step 6. Otherwise, the pairing is
canceled automatically and "INCOMPLETE"
appears on the display.
To cancel pairing
Reset the ID of the S-AIR main unit. For
details, see "To set the ID of the S-AIR sub
unit" (page 50). You can set the same ID as
before.
52
US