How To Operate; Hose Assembly And Tool Storage; Floor/Carpet Cleaning; Above Floor Cleaning - Dirt Devil Featherlitea Owner's Manual

Diagram 1 Diagram 2
Diagram 3 Attach Tools
Attach
flexible hose
to
cleaner.
Insert
hose handle into side of
cleaner.
A. Telescopic Wand
6 . Crevice
Tool
Press down f~rrnly. C 2-~n-1 tool D. Qulck Cord
Rel e ase.
HOSE ASSEMBLY AND TOOL STORAGE
1. AlTACH HOSE: Attach the flexible hose to the cleaner (Diagram 1). Match the slots on the hose to the tabs on the hose inlet (Diagram IA).
Push down firmly on the cuff and turn clockwise. Insert the hose handle into the side of the cleaner. Press down firmly to secure (Diagram 2).
2. ATTACH TOOLS: (Diagram 3) (A) Slide 2-in-1 tool onto tool clip on the back panel with bristles facing out. (B) Slide the Telescopic
wand, small end down, into the round slot behind handle. (C) Slip crevice tool into square slot behind handle.
3. CORD STORAGE: For tidy cord storage, wrap cord around hooks on back of cleaner. The Quick Cord Release turns for easy access
to the cord (Dl.
HOW TO OPERATE
1. Plug cord into electrical outlet. 2. Turn cleaner "on". Power pedal located on left side of back of unit (Diagram
1). 3. To release handle push pedal to the side with foot (Diagram 2). 4. Use cord guide to store cord out of way while vacuuming.
FLOORlCARPET CLEANING
1. Handle should be in the upright position before adjusting the carpet setting (Diagram 4a). Adjust lever to match the surface being cleaned
(Diagram 3). Once height is selected the nozzle will go to the correct position. Pull and turn the selector to the desired position
before proceeding to clean. If the cleaner is difficult to push, adjust to a higher carpet level setting.
2. Move the handle and adjust it to the desired position for (a) storing the upright, (b) operating the cleaner, and (c) depress the handle
release pedal again to clean under low furniture (Diagram 4).
3. CarpetIHose Selector located on the lower back of the cleaner should be pointed up for the carpet cleaning (Diagram 5) and
to the left for hose cleaning (Diagram 5a).
NOTE: Rotating brush could cause area rug fringe to become tangled within cleaner. Use caution when vacuuming throw rugs with fringe.
ABOVE FLOOR CLEANING
Cleaner must be in the upright position to lift the rotating brush off the carpet when cleaning above the floor.
1. Pull and turn the CarpetlHose Selector counterclockwise to the "hose" position to open up airflow to the hose (Diagram 5a).
CAUTION: Brush agitator continues to rotate while hose is removed or in use and at all times while cleaner is on. Keep hair, loose
clothing, fingers, and all parts of body away from brush area while cleaner is on.
2. Put cleaner in its upright position.
3. Remove the hose from the side of the cleaner using the handle (Diagram 6).
4. Choose any of the handy accessories or use the hose alone. Simply push the attachment firmly onto the end of the wand or hose
handle. To remove tool, twist and pull apart gently.
5. If additional length is needed use the telescopic wand (See Diagram 1, page 6).
5